BobCat E35 – HYDRAULIC PUMP – Gear Pump Disassembly And Assembly

Remove the two bolts (Item 1) and gear pump (Item 2)[Figure 20-50-35].

Installation: Tighten the bolts to 26 – 32 N•m (19 – 24 ft-lb) torque.

Remove the O-rings (Item 1) [Figure 20-50-36].

Remove the two bolts (Item 1) and cover (Item 2) [Figure 20-50-37].

Installation: Tighten the bolts to 26 – 32 N•m (19 – 24 ft-lb) torque.

Remove the thrust plate (Item 1) [Figure 20-50-38].

Remove the O-rings (Item 1) [Figure 20-50-39].

Inspect the bushings (Item 1) [Figure 20-50-40] for wear or damage.

NOTE: The bushings are not serviceable. If the bushings are worn or damaged, replace the cover assembly (Item 2) [Figure 20-50-40].

Remove the gears (Item 1) [Figure 20-50-41].

Inspect the bushings (Item 1) [Figure 20-50-42] for wear or damage.

NOTE: The bushings are not serviceable. if the bushings are worn or damaged, replace the housing assembly (Item 2) [Figure 20-50-42].

 

Leave a Reply

Your email address will not be published. Required fields are marked *