BobCat E35 – HVAC DUCT – Removal And Installation

Remove the floor mat.

Remove the eight screws (Item 1) and cover (Item 2) [Figure 70-150-1].

Remove the four bolts (Item 1) [Figure 70-150-2].

Loosen the set screws (Item 1) [Figure 70-150-3] and remove the control knobs.

Remove the nuts (Item 1) [Figure 70-150-4] and push the controls into the duct.

Tilt the duct toward the center of the excavator.
Disconnect the A/C switch wire harness (Item 1) [Figure 70-150-5].

Remove the duct from the excavator.


Leave a Reply

Your email address will not be published. Required fields are marked *