BobCat E35 – HEATER VALVE – Removal And Installation

Drain the radiator. (See Removing And Replacing Coolant on Page 10-100-3.)

Remove the right upperstructure cover. (See Removal And Installation on Page 40-80-1.)

Remove the battery. (See Removal And Installation on Page 50-20-2.)

Cut and remove the cable ties (Item 1). Remove the hoses (Item 2) [Figure 70-140-1].

Disconnect the wire harness (Item 1) [Figure 70-140-2].

Remove the nuts (Item 1) [Figure 70-140-3] and [Figure 70-140-4].

Remove the valve (Item 1) [Figure 70-140-5].


Leave a Reply

Your email address will not be published. Required fields are marked *