BobCat E35 – HEATER COIL – Removal And Installation

Remove the engine coolant. (See Removing And Replacing Coolant on Page 10-100-3.)

Remove the HVAC Duct. (See Removal And Installation on Page 70-150-1.)

Disconnect the wire harness (Item 1) [Figure 70-120-1].

Cut and remove the cable tie (Item 1). Remove the clips (Item 2) [Figure 70-120-2].

Remove the center floor panel. Remove the two screws and remove the bracket (Item 1) [Figure 70-120-3].

Disconnect the heater hoses (Item 1) [Figure 70-120-4].

Remove the coil (Item 1) [Figure 70-120-5].

 

Leave a Reply

Your email address will not be published. Required fields are marked *