BobCat E35 – FUEL SYSTEM – Fuel Injector Removal And Installation

Remove the air cleaner. (See Removal And Installation on Page 60-40-1.)

Remove the nut and wire harness (Item 1) [Figure 60-70-24].

Remove the nuts (Item 1) [Figure 60-70-25] from the two remaining glow plugs.

Remove the connecting strap (Item 2) [Figure 60-70-25] from the glow plugs.

Cut and remove the cable tie (Item 1). Remove the fuel lines (Item 2) [Figure 60-70-26].

Remove the bolts (Item 1) and bracket (Item 2) [Figure 60-70-27].

Remove the fuel lines (Item 3) [Figure 60-70-27].

Remove the fuel line (Item 1) and bolts (Item 2) [Figure 60-70-28].

Remove the tube line (Item 3) [Figure 60-70-28].

Installation: Always install new gaskets (Item 1) [Figure 60-70-29] when reinstalling the tubeline and bolts.

Remove the bolts (Item 1) and clamps (Item 2). Remove the injector nozzles (Item 3) [Figure 60-70-30].

NOTE: Replace the copper washer (Item 1) and O-ring (Item 2) [Figure 60-70-31] anytime new or used fuel injectors are installed.

 

Leave a Reply

Your email address will not be published. Required fields are marked *