BobCat E35 – EVAPORATOR COIL – Removal And Installation

Remove the blower fan. (See Removal And Installation on Page 70-130-1.)

Remove the expansion valve. (See Removal And Installation on Page 70-100-1.)

Remove the heater coil. (See Removal And Installation on Page 70-120-1.)

Remove the four bolts (Item 1) and cover (Item 2) [Figure 70-110-1].

Disconnect the wire harness (Item 1) [Figure 70-110-2].

Remove the clips (Item 1) [Figure 70-110-3].

Remove the evaporator (Item 1) [Figure 70-110-4].

Remove the sending unit (Item 1) [Figure 70-110-5] from the evaporator line.

Inspect the evaporator coil for leaks, and replace as needed.

Clean with low water or air pressure.

 

Leave a Reply

Your email address will not be published. Required fields are marked *