BobCat E35 – ENGINE SPEED CONTROL – Auto Idle Controller Removal And Installation

Remove the instrument panel / controller. (See Removal And Installation on Page 50-100-1.)

Disconnect the wire harness from the control (Item 1) [Figure 60-20-3].

Remove the nuts (Item 1) [Figure 60-20-4] and [Figure 60-20-5].
Remove the controller.
After installing the controller, the engine speed control system must be calibrated. (See Calibration on Page 60-20-3.)


Leave a Reply

Your email address will not be published. Required fields are marked *