BobCat E35 – ENGINE COOLING SYSTEM – Radiator Removal And Installation

Remove the hydraulic reservoir. (See Removal And Installation on Page 20-140-1.)

Remove the oil cooler. (See Removal And Installation on Page 20-150-1.)

Drain the coolant. (See Removing And Replacing Coolant on Page 10-100-3.)

Remove the top hose (Item 1) and overflow hose (Item 2). Remove the three bolts (Item 3) [Figure 60-50-1] and remove the fan guard.

Remove the nuts (Item 1) [Figure 60-50-2].

Remove the bolt (Item 1) [Figure 60-50-3] and remove the bracket.

Remove the lower hose (Item 1). Remove the nuts (Item 2) [Figure 60-50-4] from the bottom of the radiator.

Remove the nuts (Item 1) [Figure 60-50-5] and [Figure 60-50-6] from the top of the radiator.

Remove the radiator.

Remove the fasteners (Item 1) [Figure 60-50-7] and [Figure 60-50-8].

Remove the shroud.

Remove the fasteners (Item 1). Remove the bottom bracket (Item 2) [Figure 60-50-9].

Remove the bolts (Item 1) and remove the top brackets (Item 2) [Figure 60-50-10].


Leave a Reply

Your email address will not be published. Required fields are marked *