BobCat E35 – CYLINDER HEAD – Glow Plugs Removal And Installation

Remove the air cleaner. (See Removal And Installation on Page 60-40-1.)

Disconnect the negative (-) cable from the battery.

Remove the nut and wire harness (Item 1) [Figure 60-80-2].

Remove the nuts (Item 1) [Figure 60-80-3] from the two remaining glow plugs.

Remove the connecting strap (Item 2) [Figure 60-80-3] from the glow plugs.

Remove the three glow plugs (Item 1) [Figure 60-80-4].

Installation: Tighten the glow plugs to 15 – 20 N•m (11 – 15 ft-lb) torque.


Leave a Reply

Your email address will not be published. Required fields are marked *