BobCat E35 – CYLINDER (EXTENDABLE ARM) – Disassembly

Clean the outside of the cylinder before disassembly.

Use the following tools to disassemble the cylinder:

MEL1074 – O-ring Seal Hook
MEL1075 – Adjustable Gland Nut Wrench
MEL1075-2 – Special Offset Pins

Hold the hydraulic cylinder over a drain pan and move the rod in and out slowly to remove the fluid from the cylinder.

Remove the hoses (Item 1) [Figure 20-28-5] from the cylinder.

Put the base end of the cylinder in a vise.

Insert the adjustable gland nut wrench into the two holes (Item 1) [Figure 20-28-6] to loosen the head.

Remove the head and the rod assembly from the cylinder [Figure 20-28-7]. Put the rod end in a vise.

Remove the nut (Item 1), piston (Item 2) and head (Item 3) [Figure 20-28-7].

Remove the seal (Item 1) and O-ring (Item 2) [Figure 20-28-8] from the piston.

Remove the O-ring (Item 1) and the back-up ring (Item 2) [Figure 20-28-9] from the head.

Remove the O-ring (Item 3) [Figure 20-28-9].

Remove the wiper seal (Item 1) and rod seal (Item 2) from the inside of the head (Item 3) [Figure 20-28-10].

Remove plug (Item 1) and O-ring (Item 2) [Figure 20-28-11].

Remove the bushing (Item 1) [Figure 20-28-12].

 

Leave a Reply

Your email address will not be published. Required fields are marked *