BobCat E35 – CYLINDER (CLAMP) – Testing

Remove the snap ring (Item 1) [Figure 20-26-1] and washer from the clamp cylinder pin.

Remove the pin (Item 1) [Figure 20-26-2] from the rod end of the clamp cylinder.

Start the engine and retract the clamp cylinder (Item 1) [Figure 20-26-3].

Stop the engine.

Disconnect the hydraulic hose (Item 1) [Figure 20-26-4] from the base end of the cylinder.

Plug the hose (Item 1) [Figure 20-26-4].

Start the engine and retract the cylinder.

If there is any oil leakage from the base end fitting (Item 2) [Figure 20-26-4] on the cylinder, remove the cylinder for repair or replacement.


Leave a Reply

Your email address will not be published. Required fields are marked *