BobCat E35 – CYLINDER (CLAMP) – Removal And Installation

Remove the snap rings (Item 1) [Figure 20-26-5] and washers.

Remove the pin (Item 1) [Figure 20-26-6].
Start the engine and retract the cylinder.
Stop the engine.

Disconnect the quick couplers (Item 1) and remove the hoses from the top hose guide (Item 2) [Figure 20-26-7].

Remove the hoses from the bottom hose guide (Item 1) [Figure 20-26-8].

Remove the nuts (Item 1) and bolt (Item 2) [Figure 20-26-9].

Remove the pin (Item 3) [Figure 20-26-9] and remove the cylinder.


Leave a Reply

Your email address will not be published. Required fields are marked *