Lower the work group to the ground.
Remove the floor mat. (See Removal And Installation on Page 40-110-1.)
Remove the tool box cover. (See Removal And Installation on Page 40-230-1.)
Place a block (Item 1) [Figure 20-23-6] under the rod end of the boom swing cylinder.
Remove the snap ring (Item 1) [Figure 20-23-7] and washer from the rod end pin of the cylinder.
Remove the pin (Item 2) [Figure 20-23-7].
Remove the center floor panel (Item 1) [Figure 20-23-8].
Remove the two bolts (Item 1) and rear floor panel (Item 2) [Figure 20-23-9].
Remove the hose (Item 1) [Figure 20-23-10] from the base end of the cylinder.
Remove the nuts (Item 1) and bolt (Item 2) [Figure 20-23-11].
Remove the pin (Item 1) [Figure 20-23-12] from the base end of the cylinder.
Slide the cylinder forward and remove the grease fitting hose (Item 1) [Figure 20-23-13].
Remove the hose (Item 1) [Figure 20-23-14]
Remove the cylinder.
