BobCat E35 – CRANKSHAFT AND PISTONS – Cylinder Bore – Checking

Use a gauge to check the inside measurement of the cylinder bore [Figure 60-90-12].

Measure the six points as shown in [Figure 60-90-13] to find the maximum wear.

The specifications are 87,0 – 87,02 mm (3.425 – 3.426 in).
The wear limit is +0,15 mm (+0.006 in).

If the cylinder bore is not within specifications, re-bore the cylinder for oversize piston.


Leave a Reply

Your email address will not be published. Required fields are marked *