BobCat E35 – CRANKSHAFT AND PISTONS – Connecting Rod Alignment

NOTE: The small end bushing is the basis of this check, check the bushing for wear before doing this check.

Install the piston pin into the connecting rod.

Install the connecting rod on an alignment tool.

Put the gauge over the piston pin and move it against the face plate.

If the gauge does not fit squarely against the face plate, measure the space between the gauge and face plate [Figure 60-90-14].

If the measurement exceeds the allowable limit, replace the connecting rod.


Leave a Reply

Your email address will not be published. Required fields are marked *