BobCat E35 – CONTROLLER (S/N A93K18000 & ABOVE AND AC2P15000 & ABOVE) (GATEWAY AND AUXILIARY) – Gateway Controller Removal and Installation

Open the right side cover.

Cut and remove the cable ties (Item 1). Reposition the wire harness (Item 2) [Figure 50-102-1].

Remove the nut (Item 1) [Figure 50-102-2].

Remove the screws (Item 1) [Figure 50-102-3].

Remove the screws (Item 1) [Figure 50-102-4].
Reposition the fuse panel.

Disconnect the wire harness (Item 1) and remove the screws (Item 2) [Figure 50-102-5].

NOTE: The wire harness connectors are keyed and will only plug in one way.

Remove the gateway controller from the excavator.

Remove the bolts (Item 1) and bracket (Item 2) [Figure 50-102-6].


Leave a Reply

Your email address will not be published. Required fields are marked *