BobCat E35 – CONDENSER – Removal And Installation

Open the tailgate.

Evacuate the A/C system. (See Reclamation And Charging With Recovery / Charging Unit on Page 70-40-3.)

Open the right side cover.

Mark the A/C hoses for proper installation.

Remove the hose (Item 1) [Figure 70-60-1] from the condenser.

Cap the hose and plug the fitting on the condenser.

Installation: Tighten the hose (Item 1) [Figure 70-60-1] to 15 – 17 N•m (11 – 13 ft-lb) torque.

Remove the hose (Item 1) [Figure 70-60-2] from the condenser.

Cap the hose and plug the fitting on the condenser.

Installation: Tighten the hose (Item 1) [Figure 70-60-2] to 20 – 27 N•m (15 – 20 ft-lb) torque.

Loosen the clamp (Item 2) [Figure 70-60-2].

Remove the tie-strap (Item 1) [Figure 70-60-3].

Remove the clips (Item 2) [Figure 70-60-3] and remove the rod.

Remove the condenser from the excavator.

 

Leave a Reply

Your email address will not be published. Required fields are marked *