BobCat E35 – CLAMP – Removal And Installation

Remove the bucket. (See Operation & Maintenance Manual for correct removal procedure.)
Lower the clamp to the ground.

Remove the snap ring (Item 1) [Figure 40-180-1] and washers from the rod end of the clamp cylinder.

Remove the pin (Item 1) [Figure 40-180-2].

Remove the nuts and bolt (Item 1) [Figure 40-180-3].

Remove the pin (Item 1) and clamp (Item 2) [Figure 40-180-4].

 

Leave a Reply

Your email address will not be published. Required fields are marked *