BobCat E35 – BOOM – Removal And Installation

Remove the arm. (See Removal And Installation on Page 40-160-1.)
Remove the boom cylinder. (See Removal And Installation on Page 20-20-3.)

Disconnect the wire harness (Item 1) [Figure 40-150-1].
Cut and remove the cable ties (Item 2) [Figure 40-150-1].

Mark and remove the hoses (Item 1) [Figure 40-150-2].

Remove the nuts (Item 1), bolt (Item 2) and pin (Item 3) [Figure 40-150-3].
Remove the boom (Item 4) [Figure 40-150-3].

Remove the seals (Item 1) [Figure 40-150-4] from both sides of the boom.
Remove the bushings from both sides of the boom.
Install the new bushings in the boom.

Install the bushings until they are seated 5 mm (0.197 in) in the pin boss [Figure 40-150-5] on both sides of the boom.
Install new seals on both sides of the boom.

 

Leave a Reply

Your email address will not be published. Required fields are marked *