BobCat E35 – BLADE CONTROL LEVER – Removal And Installation

Remove the right console cover. (See Console Cover Removal And Installation on Page 40-50-1.)

Cut and remove the cable tie (Item 1). Disconnect the wire harness (Item 2) [Figure 20-170-9].

Mark and remove the four hoses (Item 1) [Figure 20-170-10].

Remove the bolts (Item 1) [Figure 20-170-11] and [Figure 20-170-12].

Tilt the control away from the console and remove the two hoses (Item 1) [Figure 20-170-13].

Remove the control.

 

Leave a Reply

Your email address will not be published. Required fields are marked *