BobCat E35 – BLADE CONTROL LEVER – Handle Removal And Installation

Remove the right console cover. (See Console Cover Removal And Installation on Page 40-50-1.)

Cut and remove the cable tie (Item 1) [Figure 20-170-1].

Disconnect the wire harness (Item 1) [Figure 20-170-2].

Remove the connector lock (Item 1) [Figure 20-170-3] from the connector.

Depress the wire terminal tabs and remove the wires from the back of the electrical connector [Figure 20-170-4].

Installation: Re-bend the tab (Item 1) [Figure 20-170-5] on each wire before installing the electrical connector.

Installation: The wires must be installed in the proper locations in the wire connector, listed below:
A Green
B Brown
C Red
D Black
E White

Check each wire to be certain the tab locks into position.

Cut and remove the cable tie (Item 1) [Figure 20-170-6].

Route the harness (Item 1) [Figure 20-170-7] out through the top of the dust boot.

Loosen the locknut (Item 1) and remove the handle (Item 2) [Figure 20-170-8].


Leave a Reply

Your email address will not be published. Required fields are marked *