BobCat E35 – BATTERY – Removal And Installation

Open the right side cover.

Disconnect the negative (-) cable (Item 1) [Figure 50-20-3] first.
Disconnect the positive (+) cable (Item 2) [Figure 50-20-3].
Remove the bolt (Item 3) [Figure 50-20-3] and remove the hold down clamp.
Remove the battery.
Always clean the terminals and the cable ends, even when installing a new battery.
Install the battery. Install the hold down clamp and tighten the bolts.
Connect the battery cables. Connect the negative (-) cable (Item 1) [Figure 50-20-3] last to prevent sparks.


Leave a Reply

Your email address will not be published. Required fields are marked *