BobCat E35 – ANGLE BLADE – Removal And Installation

Raise the blade fully and install jack stands (Item 1) [Figure 30-11-1] under the blade arms.

Attach a chain (Item 1) [Figure 30-11-2] and hoist to both ends of the blade.

Apply slight upward pressure on the blade.

Remove the nuts (Item 1), bolt (Item 2) and pin (Item 3) [Figure 30-11-3] from the rod end of the angle blade cylinder.

Remove the nut (Item 1), bolt (Item 2) and pin (Item 3) [Figure 30-11-4].

Remove the angle blade.


Leave a Reply

Your email address will not be published. Required fields are marked *