BobCat E35 – ANGLE BLADE CYLINDER – Removal And Installation

Lower the bucket and blade to the ground.

With the engine off, turn the key to the ON position, lower the console and move the blade lever. Press and hold the two speed button to activate angle blade mode, move the lever again to relieve hydraulic pressure.

Remove the nuts (Item 1) and shield (Item 2) [Figure 20-27-5].

Remove the hose (Item 1) [Figure 20-27-6].

Remove the nuts (Item 1), bolt (Item 2) and pin (Item 3) [Figure 20-27-7] from the rod end of the angle blade cylinder.

Reposition the cylinder and remove the hose (Item 1), [Figure 20-27-8] from the base end of the angle blade cylinder.

Remove the nut (Item 1), bolt (Item 2) and pin (Item 3) [Figure 20-27-9] from the base end of the angle blade cylinder.

Remove the cylinder.

 

Leave a Reply

Your email address will not be published. Required fields are marked *