BobCat 753 – TRACTION LOCK – Guide Removal

The part number listed will be needed to do the following procedure:

P/N 6633583 – Polyurethane

Raise the loader lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.)

Raise the loader operator cab. (See Raising The Operator Cab on Page 10-30-1.)

Disconnect and remove the engine speed control. (See Removal And Installation on Page 70-20-1.)

Remove the control panel from the loader. (See Removal and Installation on Page 50-100-1.)

Remove the traction lock solenoid assembly. (See Solenoid Removal And Installation on Page 60-110-2.)

Remove the center chaincase cover [Figure 60-110-8].
(See Center Cover Removal And Installation on Page 40-30-3.)

NOTE: Bolt (Item 1) is on the rear of the chaincase cover, notice the direction of the groove (Item 2) [Figure 60-110-9] in the traction lock guides.

To remove the traction lock guides remove the four bolts (Item 1) [Figure 60-110-10].

Thoroughly clean the polyurethane from the chaincase cover (Item 1), bolts (Item 2) and traction lock guides (Item 3) [Figure 60-110-11] and dry.


Leave a Reply

Your email address will not be published. Required fields are marked *