BobCat 753 – STARTER (VALEO) – Removal And Installation

Stop the engine and open the rear door.

Remove the negative (-) and positive (+) cables from the battery.

Disconnect the ground wire (Item 1) [Figure 60-41-5] from the starter.

Disconnect the engine harness power wire and positive (+) battery cable from the starter solenoid terminal (Item 2) [Figure 60-41-5].

Installation: Tighten the nut to 10.8-12.3 ft.-lbs. (14,7-16,7 Nm) torque.

Disconnect the tan wire (Item 3) [Figure 60-41-5] from the R terminal on the starter solenoid.

Disconnect the brown wire (Item 4) [Figure 60-41-5] from the S terminal on the starter solenoid.

Remove the mounting bolts (Item 5) [Figure 60-41-5] from the starter.

Remove the starter from the engine.

Installation: Tighten the three mounting bolts to 25-28 ft.-lbs. (34-38 Nm) torque.

Reverse the removal procedure to install the starter.


Leave a Reply

Your email address will not be published. Required fields are marked *