BobCat 753 – STARTER (NIPPONDENSO) – Removal And Installation

Stop the engine and open the rear door.

Remove the negative (-) and positive (+) cables from the battery.

Remove the starter mounting bolt (Item 1) and disconnect the ground wire (Item 2) [Figure 60-40-3]
from the starter.

Disconnect the engine harness power wire and positive (+) battery cable starter solenoid terminal (Item 1) [Figure 60-40-4].

Disconnect the tan wire (Item 2) [Figure 60-40-4] from the R terminal on the starter solenoid.

Disconnect the brown wire (Item 3) [Figure 60-40-4] from the S terminal on the starter solenoid.

Remove the mounting bolts (Item 4) [Figure 60-40-4] from the starter.

Remove the starter from the engine.

Installation: Tighten the three mounting bolts to 25-28 ft.-lbs. (34-38 Nm) torque.

Reverse the removal procedure to install the starter.


Leave a Reply

Your email address will not be published. Required fields are marked *