BobCat 753 – RECONDITIONING THE ENGINE – Fuel Camshaft Removal And Installation

Remove the timing gearcase cover. (See Timing Gearcase Cover Removal And Installation on Page 70-100-7.)

Remove the idler gear. (See Idler Gear And Camshaft Removal And Installation on Page 70-100-9.)

Remove the bolt (Item 1) from the retainer plate (Item 2) [Figure 70-100-43].

Installation: Tighten the bolt to 60-72 in.-lbs. (6,8-8,1 Nm) torque.

Remove the fuel camshaft retainer plate (Item 2) [Figure 70-100-43].

Remove the fuel camshaft and fork lever assembly (Item 1) [Figure 70-100-44] at the same time.


Leave a Reply

Your email address will not be published. Required fields are marked *