Stop the engine and open the rear door.
Loosen the radiator cap (Item 1) [Figure 70-50-1] from the radiator fill neck.
Remove the rear grill. (See Removal And Installation on Page 50-60-2.)
Open the drain valve (Item 1) [Figure 70-50-2] on the engine block and drain the coolant into a container.
Loosen the hose clamp (Item 1) [Figure 70-50-3] from the left side radiator hose and disconnect the hose from the radiator.
Remove the radiator mounting bolt (Item 2) [Figure 70-50-3].
Loosen the hose clamp (Item 1) [Figure 70-50-4] from the right side radiator hose and disconnect the hose from the radiator.
Remove the radiator mounting bolt (Item 2) [Figure 70-50-4].
Installation: Torque the radiator bolts to 11-13 ft.-lbs. (15-17 Nm) torque.
Raise the oil cooler (Item 2) [Figure 70-50-5] and set it up out of the way.
Remove the two rubber stops (Item 1) [Figure 70-50-5] & [Figure 70-50-6] from the top of the radiator.
Lift the radiator (Item 1) [Figure 70-50-7] up and remove it from the loader.
Reverse the above procedure to install the radiator.
