BobCat 753 – OPERATOR SEAT – Removal And Installation

Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.)

Remove the four seat mounting nuts (Item 1) [Figure 50-30-1] and washers from the operator seat mounting studs.

Installation: Tighten the mounting nuts to 20 ft.-lbs. (27 Nm) torque.

NOTE: Ensure the washers are installed.

Lower the cab and install one of the mounting washers and nuts [Figure 50-30-2].

NOTE: With the seat removed the cab will raise.

Reverse the removal procedure to install the operator seat.


Leave a Reply

Your email address will not be published. Required fields are marked *