BobCat 753 – INSTRUMENT PANEL – Removal And Installation

Remove the front light. (See Front Removal And Installation on Page 60-60-1.)

Remove the three mounting bolts (Item 1) [Figure 60-50-6] or [Figure 60-50-7].

Installation: Be careful to not overtighten the instrument panel mounting bolts to prevent stripping of the threaded holes in the panels.

Pull the left instrument panel down and disconnect the wire harness connectors (Item 1) [Figure 60-50-8] or [Figure 60-50-9] from the panel.

Remove the panel.

Reverse the removal procedure to install the instrument panel.


Leave a Reply

Your email address will not be published. Required fields are marked *