BobCat 753 – HYDRAULIC FLUID RESERVOIR – Removal And Installation

Start the engine. Raise the lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.)

Stop the engine.

Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.)

Drain the hydraulic fluid reservoir [Figure 20-80-1]. (See Replacing Hydraulic Fluid on Page 10-120-3.)

Mark and disconnect the hoses (Item 1) [Figure 20-80-2] from the hydraulic fluid reservoir.

Remove the hydraulic reservoir bracket (Item 1) by removing the two mounting bolts (Item 2) [Figure 20-80-3] .

Remove the reservoir.


Leave a Reply

Your email address will not be published. Required fields are marked *