BobCat 753 – HYDRAULIC CONTROL VALVE (FOOT CONTROL) – Lift And Tilt Lock Block Removal And Installation

Remove the lock solenoids (Item 1) [Figure 20-40-68] & [Figure 20-40-69] from the lock block.

Remove the rubber Boot (Item 2) [Figure 20-40-68] & [Figure 20-40-69]. (See Rubber Boot on Page 20-40-21.)

Remove the block [Figure 20-40-70].

NOTE: The lock block must be clean and oil free. (Oil can cause the solenoids not to function properly.)

 

Leave a Reply

Your email address will not be published. Required fields are marked *