BobCat 753 – HYDRAULIC CONTROL VALVE (FOOT CONTROL) – BICSTM Valve Check Valve Disassembly And Assembly

Remove the check valve (Item 1) [Figure 20-40-38].

Installation: Tighten the valve to 20 ft.-lbs. (27 Nm) torque.

Remove the O-rings (Item 1) and back-up ring (Item 2) [Figure 20-40-39].

Install new O-rings (Item 1) and back-up ring (Item 2) [Figure 20-40-39] on the check valve.

Check valve (Item 3) [Figure 20-40-39] has a rating of 5-10 PSI.

Clean and inspect the screen (Item 1) [Figure 20-40-40] on the end of the valve.

Reverse the removal procedure to install the BICSTM check valve.

 

Leave a Reply

Your email address will not be published. Required fields are marked *