BobCat 753 – HYDRAULIC CONTROL VALVE (ADVANCED CONTROL SYSTEM) (ACS) – Tilt Spool Removal And Installation

Remove the actuators (Item 1) [Figure 20-41-70] from the control valve. (See Actuator Removal And Installation
on Page 20-41-8.)

Remove the screws (Item 1) [Figure 20-41-71] from the end cap.

Installation: Tighten the bolt to 90-100 in.-lbs. (10,2-11,3 Nm) torque.

Remove the spool assembly (Item 1) [Figure 20-41-72] and seal from the control valve.

Assembly: Always use a new spool seal and new O-rings.

 

Leave a Reply

Your email address will not be published. Required fields are marked *