BobCat 753 – HYDRAULIC CONTROL VALVE (ADVANCED CONTROL SYSTEM) (ACS) – Lift Spool Removal And Installation

Remove the actuator (Item 1) [Figure 20-41-67] from the control valve. (See Lift Spool Removal And Installation on Page 20-41-22.)

Remove the screws (Item 1) [Figure 20-41-68] from the cap.

Installation: Tighten the bolt to 90-100 in.-lbs. (10,2-11,3 Nm) torque.

Remove the spool assembly (Item 1)[Figure 20-41-69] and seal from the control valve.

Assembly: Always use a new spool seal and new O-rings.

 

Leave a Reply

Your email address will not be published. Required fields are marked *