BobCat 753 – HYDRAULIC CONTROL VALVE (ADVANCED CONTROL SYSTEM) (ACS) – BICSTM Valve, Solenoid Removal and Installation

Remove the mounting nut (Item 1) [Figure 20-41-42] from the solenoid cartridge.

Installation: Tighten the mounting nut to 53 in.-lbs. (6 Nm) torque.

Remove the solenoid (Item 2) [Figure 20-41-42].

NOTE: The solenoid resistance valve is (8-10 ohms).

Remove the O-rings (Item 1) [Figure 20-41-43] from both ends of the solenoid.

Remove the solenoid cartridge (Item 1) [Figure 20-41-44].

Installation: Tighten the cartridge to 20 ft.-lbs. (27 Nm) torque.

Remove the O-rings (Item 1) and back-up rings (Item 2) [Figure 20-41-45] from the cartridge.

Clean all parts in solvent and dry with compressed air.

Inspect all parts for wear and replace any showing excessive wear.

NOTE: The screen (Item 3) [Figure 20-41-45] may be cleaned with solvent. If it is torn or worn it
needs to be replaced.

Use only new O-rings and apply oil to all O-rings and back-up rings before installation.

Install new O-rings (Item 1) [Figure 20-41-43] & [Figure 20-41-45] and new back-up rings (Item 2) [Figure 20-41-
45] on the solenoid cartridge.



Leave a Reply

Your email address will not be published. Required fields are marked *