BobCat 753 – HYDRAULIC CONTROL VALVE (ADVANCED CONTROL SYSTEM) (ACS) – Auxiliary Spool Removal And Installation

Remove the screws (Item 1) [Figure 20-41-77] from the end cap (both sides).

Installation: Tighten the bolt to 90-100 in.-lbs. (10,2-11,3 Nm) torque.

Remove the end cap, O-ring, springs and washer (both sides) [Figure 20-41-78].

Assembly: Always use a new spool seal and new O-rings

Remove the spool (Item 1) [Figure 20-41-79].

Assembly: Put grease on all the centering spring component parts.


Leave a Reply

Your email address will not be published. Required fields are marked *