BobCat 753 – HYDRAULIC CONTROL VALVE (ADVANCED CONTROL SYSTEM) (ACS) – Auxiliary Electric Solenoid

Remove the nut (Item 1) [Figure 20-41-80] from both solenoids.

Installation: Tighten the nut to 8-12 ft.-lbs. (11-16 Nm) torque.

Remove the end plate (Item 1) and housing (Item 2) [Figure 20-41-81].

Remove the coil (Item 1) and end plate (Item 2) [Figure 20-41-82].

Remove the solenoid valve (Item 3) [Figure 20-41-82].

Installation: Tighten valve to 8-12 ft.-lbs. (11-16 Nm) torque.

Remove and install new O-rings (Item 1) [Figure 20-41-83] on the solenoid valves.

 

Leave a Reply

Your email address will not be published. Required fields are marked *