BobCat 753 – HEATER FAN – Wire Connector Removal and Installation

Remove the plastic wedge (Item 1) [Figure 80-70-14] & [Figure 80-70-15] from the center of the blower fan motor wiring connector.

With a pointed screw driver lightly press in on the tabs (Item 1) [Figure 80-70-16] and remove the individual wires from the connector.

Reverse the disassembly procedure to assemble the heater fan.

The wiring code for the blower fan connector [Figure 80-70-17] is:

Reverse the removal procedure to install the wire connector.


Leave a Reply

Your email address will not be published. Required fields are marked *