BobCat 753 – FLYWHEEL AND HOUSING – Flywheel Removal And Installation

Remove the three belt shield clips (Item 1) [Figure 70-90-1] and remove the shield from the drive belt housing.

Loosen and remove the drive belt tensioner (Item 1) [Figure 70-90-2].

Remove the drive belt. (Refer to Contents Page 30-01 for drive belt adjustment procedure.)

Remove the six mounting bolts (Item 1) from the engine flywheel (Item 2) [Figure 70-90-3].

Installation: Apply engine oil to the threads and seats before tightening. Tighten to 72-80 ft.-lbs. (98-108 Nm) torque.

Remove the flywheel from the engine.

Installation: Be sure to align the hole (Item 3) [Figure 70-90-3] in the flywheel with the pin located on the crankshaft.

Reverse the removal procedure to install the flywheel.


Leave a Reply

Your email address will not be published. Required fields are marked *