Raise the lift arms and install an approved lift arm device.
(See Installing Lift Arm Support Device on Page 10-20-1.)
Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.)
Remove the two mounting bolts (Item 1) [Figure 70-20-1] and nuts from the speed control mounting bracket.
Installation: Tighten the mounting bolts and nuts evenly until the speed control lever moves back and forth at a comfortable tension.
Pull the speed control away from the loader frame and disconnect the speed control rod (Item 1) [Figure 70-20-2] from the control.
Installation: Be sure to install the control rod in the bottom hole of the speed control.
Installation: Install the stop bracket (Item 1) [Figure 70-20-3] in the same location. It is necessary for the front and rear stop on the bracket to be located correctly.
Reverse the removal procedure to install the engine speed control.
