BobCat 753 – ENGINE COMPONENTS AND TESTING – Fuel Shut-Off Solenoid Removal And Installation

Stop the engine and open the rear door.

Disconnect the connector (Item 1) [Figure 70-70-12].

Remove the linkage mounting nut (Item 1) [Figure 70-70-13] from the fuel injector pump.

Removing the mounting bolts (Item 2) [Figure 70-70-13] of the fuel shut-off solenoid.

Installation: Reverse the above procedure to install the fuel shut-off solenoid.

 

Leave a Reply

Your email address will not be published. Required fields are marked *