The Loader has a 12 volt, negative ground alternator charging system. The electrical system is protected by a
100 amp master fuse (Item 1) [Figure 60-10-1] & [Figure 60-10-2] to protect against serious system overloads that
could lead to burned up harness or loader damage. This fuse is located in the left-hand side engine compartment.
just forward of the engine harness connector.

The electrical system is also protected by fuses and relays under the fuse panel cover (Item 1) [Figure 60-10- 3] located in the cab on the steering control panel.

The fuse panel cover (Item 1) [Figure 60-10-4] & [Figure 60-10-6] has a decal inside to show the location and amp ratings.


Leave a Reply

Your email address will not be published. Required fields are marked *