BobCat 753 – CYLINDER (TILT) – Rod End Pivot Pin Bushing And Seal Replacement

Remove the old seal (both sides) from the end of the tilt cylinder [Figure 20-21-8].

Apply a light coat of grease on the new seals (Item 1) [Figure 20-21-8].

Install the new seals with the lip facing in [Figure 20-21-8].

Install the rod end of the tilt cylinder into the Bob-Tach.

Be careful not to damage the new seals during installation.

Reserve the removal procedure to install the tilt cylinder.


Leave a Reply

Your email address will not be published. Required fields are marked *