Disconnect both hydraulic hoses (Items 1 & 2) [Figure 20-21-3].
Remove the retainer nut (Item 1) [Figure 20-21-4] from the cylinder rod end pivot pin.
Installation: Tighten the retainer nut to 18-20 ft.-lbs. (24-27 Nm) torque.
Remove the grease fitting from the rod end pivot pin (Item 1) [Figure 20-21-5].
Remove the rod end pivot pin.
Remove the retainer nut (Item 1) [Figure 20-21-6] and bolt from the base end pivot pin.
Installation: Tighten the retainer nut and bolt to 18-20 ft.-lbs. (24-27 Nm) torque.
Remove the base end pivot pin (Item 1) [Figure 20-21-7].
Remove the tilt cylinder from the loader.
