BobCat 753 – CYLINDER (POWER BOB-TACH) – Checking

Tilt the Bob-Tach forward, so it is parallel to the floor [Figure 20-22-1].

Disconnect the hose (Item 1) [Figure 20-22-1] from the power Bob-Tach cylinder base end port.

Install a plug in the hose (Item 1) [Figure 20-22-2] and tighten.

Engage the parking brake. Lower the seat bar. Start the engine.

Push and hold the BOB-TACH “WEDGES UP” Switch (Front Accessory Panel).

If there is any leakage from the base end cylinder port (Item 2) [Figure 20-22-2], remove the lift cylinder for


Leave a Reply

Your email address will not be published. Required fields are marked *