BobCat 753 – CYLINDER (LIFT) – Removal And Installation

Stop the engine. Pull up on the lift arm by-pass control and move the lift pedal to release the hydraulic pressure.

Disconnect the hoses (Item 1) [Figure 20-20-3] from the lift cylinder.

Install plugs in the hoses and tighten.

Remove the retainer bolt (Item 1) [Figure 20-20-4] and nut from the lift arm pin (both sides).

Installation: Tighten the bolt and nut to 18-20 ft.-lbs. (24-27 Nm) torque.

NOTE: Remove the air cleaner (See AIR CLEANER SERVICE on Page 10-80-1.) to remove the left rear pivot pin. The pin must be driven out from the engine compartment.

Remove the lift arm pivot pin (Item 1) [Figure 20-20-5] (both sides).

Remove the retainer bolt (Item 1) [Figure 20-20-6] and nut from the lift cylinder rod end pivot pin (both sides).

Installation: Tighten the bolt and nut to 18-20 ft.-lbs. (24-27 Nm) torque.

Remove the lift cylinder rod end pivot pin (Item 2) [Figure 20-20-6].

Remove the lift cylinder (Item 3) [Figure 20-20-6] from the loader.

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *