BobCat 753 – COOLING FAN – Blower Disassembly And Assembly

Remove the lock nut (Item 1) and spacer (Item 2) [Figure 70-60-14].

Installation: Tighten the nut to 45-55 ft.-lbs. (61-75 Nm) torque.

Use the following procedure to remove the fan from the shaft.

Install the nut (Item 1) [Figure 70-60-15] on the tapered shaft to protect the shaft and threads.

Install the puller on the fan as shown [Figure 70-60-15].

As the center bolt (Item 2) [Figure 70-60-15] is tightened, periodically strike the bolt head to loosen the fan from the shaft.

Remove the fan from the tapered shaft [Figure 70-60-16].

To remove the blower housing mounting plate, remove the six bolts (Item 1) [Figure 70-60-17].


Leave a Reply

Your email address will not be published. Required fields are marked *