BobCat 753 – CONTROL PEDALS – Tilt Foot Pedal Linkage Removal And Installation

Remove the hairpin clip and cross-pin (Item 1) [Figure 50-90-9] to disconnect the tilt foot pedal linkage from the
control valve.

Remove the bolt (Item 1) [Figure 50-90-10] and nut from the pedal linkage.

Installation: Tighten the bolt and nut to 25-28 ft.-lbs. (34-38 Nm) torque.


Leave a Reply

Your email address will not be published. Required fields are marked *